Skip to content

Instructions on How to Replace a Shower Valve

Repairing the problem with a shower valve may require more than just an understanding of DIY. Based on the issue in your shower You may require a guide on how to take off caulk take off valves, or even seller. There may be slight differences to the steps needed for each job however this article will help you understand the procedures to be expected.

The Preliminary Actions

As with like any DIY undertaking, it’s best be aware of what must be repaired and then put together the required tools prior to start.

There are three kinds of valves that help make showers function:

  • Valve for pressure-balancing that allow an swivel hand to adjust the pressure, and also mix cold and hot water
  • Thermostatic valves that regulate the temperature of water at a predetermined amount in one direction.
  • Transfer valves and Diverter valves are activated to divert the flow of water from a bath faucet to showerheads or vice versa

If you’re experiencing water leaks around the handle or lack of control over heating of your water, then the cartridge could be the culprit. If temperature is the issue , but there’s not a leak, then the buildup of lime and dirt could be at fault. It is possible that your issues with showers could be due to issues with the plumbing inside the walls.

Whatever the case, it’s essential to research the manufacturer and model of shower component you’re looking to repair. If you’ve got the correct replacement part(s) in your possession, if you think the whole valve requires replacement, you’re ready to collect additional tools that are required:

  • Screwdrivers, Allen wrenches Channellock pliers and needle-nose pliers are likely to prove useful.
  • A knife for utility or a smaller hacksaw could be necessary to remove the escutcheon plates that are affixing the valve to wall has been sealed and it is necessary to cut off some walls for you to be able to work within your valve
  • A lime or vinegar remover can help if you think that you have buildup inside those parts that require to be taken care of.
  • Teflon thread tape as well as an soldering kit can be useful if you require replacing the entire valve assembly or using copper pipes
  • Rags and towels are beneficial for giving you additional grip and covering the entire base of the tube , or even the flooring of the shower (which prevents any nut or bolt falling down the drainage)

In actual fact, fixing the Valve

The precise design that you’ll use for your shower is going to dictate the steps that you have to follow, however the fundamental procedure to be following is:

  1. Turn off the water supply to the shower in order to make the repair easier and less messy.
  2. The drain is covered
  3. Remove the faucet, trim plate and handle, laying them out on the valve.
  4. Assess the issue, then remove the cartridge with the tools to clean it or replace it the cartridge as required. If the entire valve needs to be removed, disconnect the previous piece of piping from the new one and attach the new one.
  5. Then tighten the bolts, switch the water supply off and use the water to look for leaks. Repair any leaks if they are found.
  6. Replace the faucet handle, handle and trim plate, then clean up (possibly replace the caulk depending on the circumstances).

The outline is not complete and does not cover certain directions that should be left to the manufacturer’s guidelines or the experience of an experienced professional. If you’re seeking the expertise of a professional within Central Indiana, connect with Midwest Plumbing.